Additional Information Using the System Utilities
58 Agilent 8163A Lightwave Multimeter, Agilent 8164A Lightwave Measurement
System, & Agilent 8166A Lightwave Multichannel System, Fourth Edition
2 Move to the <Date & Time> menu option and press Enter. You see a box,
similar to Figure 32, displaying the current date and time settings.
3 Use the cursor key to move to the Date field. Press the [Edit] softkey. The day
of the month is highlighted.
4 Use the left and right cursor keys to move to the day, month or year. Edit the
day, month or year using the cursor key. Press Enter.
5 Perform steps 3 to 4 again if the date is not fully correct.
6 Use the cursor key to move to the Time field. Press the [Edit] softkey. The
hour of the day is highlighted. The 24-hour clock is used.
7 Use the left and right cursor keys to move to the hour, minute, or second. Edit
the hour, minute, or second using the cursor key. Press [OK].
8 Perform steps 6 to 7 again if the date is not fully correct.
9 When the time and date are both correct, press [Close] to return to the
configuration menu.
How to Set the GPIB Address
NOTE The default GPIB address is 20.
To set the GPIB address:
1 Press the Config hardkey.
Figure 32 Editing the Date and the Time
To Next Page
Loading...
Need help?
General
