164 Chapter 3
Mode
Two Port Insertion Loss Measurement
Mode
Avg Mode
Averaging functions are the same as defined in the Spectrum Analyzer Mode, but the
parameter values are measurement independent. So, SCPI commands are different. See
descriptions below.
Avg Mode sets the type of termination control used for the averaging function. This
determines the averaging action after the specified Averaging number has been reached.
Mode Stimulus / Response
Range Averaging | Average | Clear Normalize | Limits | Optimize |
Interference Rejection | Store As
Key Path Front-panel key
Mode Stimulus / Response
Remote Command [:SENSe]:TPILoss:AVERage:TCONtrol
EXPonential|MAXHold|REPeat|RMAXhold
[:SENSe]:TPILoss:AVERage:TCONtrol?
[:SENSe]:TPILoss:AVERage[:STATe] OFF|ON|0|1
[:SENSe]:TPILoss:AVERage[:STATe]?
Example TPIL:AVER:TCON RMAX
TPIL:AVER ON
Preset EXPonential, ON
Range EXPonential|MAXHold|REPeat|RMAXhold
Key Path
Meas Setup, Avg Mode
To Next Page
Loading...
