Publication 1756-UM050A-EN-P - December 2001
Configuring the 1756-ENBT Module 4-9
The following pop-up menu will appear.
5. Select Module Configuration, then select the Port
Configuration tab.
6. Uncheck the Obtain IP Address from BootP Server box.
7. Enter the desired IP Address, Subnet Mask, and optional
Gateway Address. The values we used for one of the 1756-ENBT
modules in the example applications are shown above.
8. Click on OK.
You can now move the module to another chassis and access it over
your network using this configuration.
AB Parts
To Next Page
Loading...
