Operating
123
0000010038-003- GB
Operating
Setting the scoring saw blade
• Setting the cutting height
• Set the blade protrusion by pressing button 2.
• Set the position of the right saw blade side
• so that both cutting edges are congruent when a test cut is made.
• Enter + 0.05 so that the scorer cuts wider than the main saw blade.
• Set the position of the left saw blade side.
• Set the scoring blade to the thickness of the main saw blade.
• If a test cut is OK, increase the cutting width by + 0.05.
When you exit the menu, the electronics saves the last values set. When the
scoring saw is switched on, the scoring blade is automatically moved to the
previously set values. When the saw drives are switched off, the scoring blade
is automatically moved to its lowest position.
If you select this menu item when the scoring saw is running, the scorer will not
travel down to its lowest position when the saw drives are switched off!
Reference:
The reference is the 2nd way of storing all 3 scoring saw blade positions.
• Pressing the Reference button for more than 3 seconds saves the values
that have been currently set.
• After adjustments have been made, the stored values can be set by pres-
sing the Reference and START buttons.
To Next Page
