Operating
92
Operating
0000010038-003- GB
Longitudinal cutting of narrow workpieces
Workpiece width < 120 mm
Tool: Circular saw blade for longitudinal cuts
Work cycle: Set the rip fence to the required cutting width. Lower the top pro-
tection hood according to the workpiece height. Push the workpiece (aligned
along the fence) and sliding table forward, using the push stick in the vicinity of
the saw blade, and push the parted workpiece beyond the riving knife. Use the
push stick from the very beginning when cutting short workpieces.
Cutting strips
Tool: Circular saw blade for fine cuts
Fig. 6-12 Longitudinal cutting
Fig. 6-13 Cutting strips
To Next Page
Loading...
