Operating
94
Operating
0000010038-003- GB
Concealed cutting, rebating
Tool: Circular saw blade for fine cuts
Work cycle: When rebating, select the cutting sequence so that the cut-out strip
is produced on the side of the blade opposite the fence. Lower the protection
hood onto the workpiece and ensure good workpiece guidance (left hand pres-
ses the workpiece against the rip fence).
Concealed cutting, grooves
Tool: Grooving tool permitted for manual feeding (max. width 20 mm)
Fig. 6-15 Concealed cutting
Fig. 6-16 Grooves
To Next Page
Loading...
