Amada WELD CHECKER MM-400A - (2) Rear

MM-400A
4. Name and Functions of Each Section
4-2
(2) Rear
 External I/O connector (1):
A connector to input signals from peripheral devices.
 External I/O connector (2):
A connector to output signals to peripheral devices.
 RS-232C/RS-485 connector:
Plug the instrument and host computer with an optional RS-232C
communication cable. Used to transfer measured values and waveform data to
the host computer.
 Toroidal coil connector:
Plug a toroidal coil into this connector.
 Voltage detection cable connector:
Plug the voltage detection cable into this connector.
 Displacement sensor connector 1
*1
:
Plug a discontinued displacement (LGK-110/LGF-125L-B/LGF-550L-B)
into this connector.
 Displacement sensor connector 2
*1
:
Plug an optional displacement sensor
*2
into this connector.
 Force sensor connector
*1
:
Plug an optional force sensor (MA-520B/521B/522B) into this connector.
 Multiconnector
*1
:
Plug an optional current/force sensor (MA-770A/771A) into this connector.
Also used to plug an external voltage/current input and shunt resistor.










⑪
⑫