MM-400A
1. Special Precautions
1-4
(2) Precautions for Handling
■ Avoid the following locations when installing the instrument:
• Humid (above 90%) locations
• Extremely hot (above 45°C) or cold (below 0°C) locations
• Near a high noise source
• Location where chemical substances, etc. are handled
• Location where condensation occurs
• Dusty location
• Location exposed to direct sunlight
• Location that is inclined, insecure, unstable, or weak
■ Check the voltage and power frequency before installation.
■ Keep the exterior clean with a soft cloth or cloth lightly dampened with water.
For stains, clean them off using a diluted neutral detergent or alcohol. Do not
use thinner or benzene as they may cause discoloration or deformation.
■ To prevent malfunction, do not allow any foreign objects such as screws or
coins to enter the instrument.
■ Operate the instrument according to the procedure described in the Operation
Manual.
■ Operate the switches and buttons with care. Rough operation or the use of a
tool or pen tip may result in damage or malfunction.
(3) Model-Specific Function
The functionality given for “force/displacement-equipped specification” in the
operation manual is available only with the corresponding model. Other functions
available are the same as those of the standard model.
Product model
MM-400A-00-00 MM-400A-00-01
Standard (no force/displacement)
Force/displacement-equipped
(4) Use of Printer
A tape is adhered to the printer on the MM-400A so that the lid does not open
during transportation. Peel the tape before using.
(5) On Disposal
This product incorporates parts containing gallium arsenide (GaAs). At the time
of disposal, separate it from general industrial waste or domestic waste and carry
out the disposal in accordance with applicable laws and regulations.
To Next Page
Loading...
