MM-400A
13. Error List and Maintenance
13-10
(3) Replacing the Fuse
A fuse will be broken in case of the occurrence of the exceeding the rated voltage
(applying overvoltage). If a fuse is broken, replace it according to the following
procedure.
WARNING
When replacing the fuse, be sure to disconnect the power cable.
a. Maintenance parts
Item Model No.
Time lag fuse (2 A) 0215002.MXP
b. Replacement procedure
1) Pull out the red fuse box from the AC inlet.
2) Remove the broken fuse.
Install a new fuse at the position where the old fuse has been removed.
To Next Page
Loading...
