MM-400A
4. Name and Functions of Each Section
4-3
Main power switch:
Switch for the main power. Set this to the ON position (– side) to start the
MM-400A.
○
11
Power cable connector:
Plug the power cable into this connector.
○
12
LAN cable connector:
Plug the LAN cable for Ethernet into this connector. The orange LED is lit
when it can be connected and is blinked when the data is being sent or
received. The green LED is not lit when operated at 10 MB/s and is lit when
operated at 100 MB/s.
*1: to are force/displacement-equipped specification function connectors.
*2: In addition to the displacement sensor, the dedicated connector and cable are
required. Refer to “(2) b in Chapter 3” for details.
To Next Page
Loading...
