Anritsu MT1810A - Page 190

Chapter 7 Remote Commands
7-72
:SENSe:MEASure:EDIagram:DIAGram:POINt?
<slot>,<interface>,<thre>[,<unit>]
Parameter <slot>=<CHARACTER PROGRAM DATA>
SLOT1 to SLOT6 Slots No. 1 to No. 6
USB11 to USB14 USB No.11 to 14
<interface>=< DECIMAL NUMERIC PROGRAM DATA>
1 to 4 Data1 to 4
Fixed to 1 if using a USB module
<thre>=<CHARACTER PROGRAM DATA>
E_3 to E_12 1E–3 to 1E–12
[<unit>]=<DECIMAL NUMERIC PROGRAM DATA>
1 to 4 Mainframe Nos. 1 to 4
When using two or more MT1810A units in serial connection, specify the
mainframe number.
Can be omitted. Mainframe No. 1 is specified when omitted.
Response <numeric>=<NR1 NUMERIC RESPONSE DATA>
1 to 128 Returns a valid point.
0 Returns 0 when all points are invalid.
Multiple valid points are delimited with a comma (,) and returned
Function Queries the valid points in each threshold during the Eye Diagram
measurement for a specific slot.
Example To query the valid points in slot No. 1 during measurement with threshold
E–3:
> :SENSe:MEASure:EDIagram:DIAGram:POINt? USB11,1,E_3
< 1,2,3,4,128
Compatibility Incompatible with existing models.