Anritsu MX269018A - Page 117

3.7 RX Measurement Mode
3-75
3
Measurement
AF1 Tone Radian (

M)
■
Summary
Sets the Deviation of AF1 signals.
Displayed when Modulation is set to

M.
■ Setting range
0.00 to 50.00 rad
However, the setting range is limited to within the range which
meets the following formula.
(AF1 Tone Frequency × AF1 Tone Radian) <100k
AF2 Tone Radian (

M)
■
Summary
Sets the Deviation of AF2 signals.
Displayed when Modulation is set to

M.
■
Setting range
0.00 to 50.00 rad
However, the setting range is limited to within the range which
meets the following formula.
(AF2 Tone Frequency × AF2 Tone Radian) <100k
AF1 Tone Depth (AM)
■
Summary
Sets the AM modulation index of AF1 signal.
Displayed when Modulation is set to AM.
■
Setting range
0 to 100%
AF2 Tone Depth (AM)
■
Summary
Sets the AM modulation index of AF2 signal.
Displayed when Modulation is set to AM.
■
Setting range
0 to 100%
AF3 – AF3 Tone
■
Summary
Selects the signal output of AF3 signal source.
This setting is enabled when the MS2830A-018/118 is installed.
■
Options
Off Does not generate signals.
On Generates Tone signals.