Service Manual i2000SR interface module
625798100.APS.5.doc Page 5 of 212
WARNING: Pinch Hazard
FSE may be exposed to pinch hazards while working on the
i2000SR IM. Be careful around moving parts while
performing diagnostic and maintenance operations.
WARNING: Probe Sharps Hazard
Follow safe sharp practices. Do not place your hand near
the probe while it is moving. Put the instrument through a
decontamination cycle and wipe the probe with a
disinfectant prior to touching or working near the probe.
Laser Safety
The laser classification scheme is used to describe the capability
of the laser or laser system to cause injury to personnel. The
higher the classification number, the greater the potential hazard.
The lasers on this workcell include Class 2 lasers.
During normal operation, the protective covers and access door
are to remain in place to prevent laser light exposure. The
protective covers and access door are to be removed only during
the servicing by qualified personnel. Do not remove the protective
cover laser warning labels. They must remain legible. The
protective housing label (label on instrument) is shown below. The
label consists of black lettering against a yellow background.
Do not remove, damage or obliterate any of the laser warning
labels. If any of the labels become damaged and/or illegible,
replace them.
LAB0033 is an illustration of the label recommended by Abbott
Safety to be placed on the i2000SR and i2000SR IM closeout
cover.
DANGER:
Class 2 Laser Radiation when open. Do not stare into beam.
Avoid eye exposure to laser light
To Next Page
Loading...