i2000SR interface module Service Manual
Page 72 of 212 625798100.APS.5.doc
− Remove obstacle
− Adjust carrier guides
• The i2000SR support bracket feet must not come in
contact with a belt, cable, or tube.
• Check the tension of belts 1, 2, 3 and 4.
Refer to the
3
Verification of belt tensioning
procedure.
• Check the track height.
− Check that the surface of the IM belt and track belts are
equal. Refer to the
3
i2000SR IM Horizontal Positioning
Check
and
i2000SR IM Vertical Positioning Check
.
Figure 64 – Belt surface difference
• Moving belts must be centered on the lane
− Refer to the
Replacement of belts 1 & 2 idler pulleys
groups
procedure.
• Quality of spinning disk
− Leading edges are flush with track belts
− Disks do not have defects
− When a carrier is not on the disk the spin rate is
consistent.
− Carriers do not stall as they transfer from the belt to the
disk.
− When a carrier is on the disk, the disk continues to spin
• Gate action
− Allows only one carrier to pass through at a time.
− When idle with a carrier over an antenna, the appropriate
LED numerical value must consistently be displayed. The value
must be constant and should not change.
− When a carrier is held at a gate, the carrier must be held
still. A small position shift can cause the RFID value to be sent
twice and result in presentation or carrier errors.
• Diverter action
− Diverter movement is smooth and without hesitation
To Next Page
Loading...