i2000SR interface module Service Manual
Page 8 of 212 625798100.APS.5.doc
NOTE:
Although the i2000SR IM can process samples independent
of the APS, the IM cannot be installed independent of the
APS.
The IM is controlled by a set of microcontrollers. The
microcontrollers are interfaced to the APS via the CAN bus and
are similar to the Tag Reader boards used to manage the
functions of the track.
The operator side contains a local user interface keypad, two
colored Input Status LEDs (green and yellow) for Routine and
Priority testing, and Instrument Indicator light (IM pole lamp)
with three lamps (red, yellow and green).
IM set-up/configuration/upgrade and device control operations
can be performed either by the APS software or by a laptop
connected to the APS computer hub via TCP-IP.
To Next Page
Loading...