Operating the System
Free Examination Procedures
4.8.2.3 Flow of Operation
Select an Auto position mode examination.
The System display will display the following.
Fig. 4-24 Auto position mode display
• The OTC will display “H”, distance to the floor.
Activate the mode by pressing the servo button.
• When auto—positioning to a Wallstand, the Wallstand detector unit will move into a basic
position.
• The OTC will automatically move to its programmed position.
• The servo mode button light indication will be switched off.
All movements are available.
4.8.2.4 Exposure
Exposure is possible when the OTC is not moving.
ARCOMA AB 1000-095-051-EN Rev. 1.1
Operation Manual
SWEDEN Page 110 2020-06-16
To Next Page
Loading...