User Interface
Automatic Collimator Control
3.2.14 System Mode
The System has a number of different modes. All modes are described below with their spe-
cial functionalities and features.
Note that depending on the particular System, different modes and actual configurations are
available.
• Free mode
• Auto position mode
• Wall flexible mode
• Table flexible mode
• Film tracking mode
• Pendulum mode, Table
• Stitching mode (toward the Table and Wall stand)
3.2.14.1 Free Mode
General Description
The Free mode is the most basic mode in the System.
The mode holds no special features or functionality. It is intended as a manual mode with a
lot of freedom in positioning and exposure, e.g. for emergency examinations or examinations
with the patient in a wheel chair or lying in a bed. This mode is available in all Systems.
The distance shown in display for Free mode is the distance to the floor.
Exposure Validation
Exposure is allowed if the stand is not moving and operating properly (not in an error state).
3.2.14.2 Auto Positioning Mode
General Description
The Auto position mode functions as the Free mode with the added functionality of automatic
positioning in the room.
Automatic positions are a number of positions that can be programmed and saved into the
System. The stand will upon activation of the servo button, move to the programmed position
chosen from the imaging unit.
The mode is intended as a flexible, easy to use mode. The mode can also be used as a park-
ing mode.
The distance (H) shown in display for Auto position mode is the distance to the floor.
Exposure Validation
Exposure is allowed if the stand is not moving and operating properly (not in an error state).
The chosen position must have been reached successfully.
ARCOMA AB 1000-095-051-EN Rev. 1.1
Operation Manual
SWEDEN Page 68 2020-06-16
To Next Page
Loading...