Cleaning
Collimator
6.2 Collimator
Follow local, national and organizational procedures regarding cleaning. The following
agents are safety to use
• Isopropanol
• Ethyl alcohol
These cleaning agents may be diluted with water for cleaning purposes.
WARNING!
Use of other cleaning agents may result in damaging the collimator or possible injury
to the user.
How to clean the collimator:
• Switch off the collimator.
• Use a damp soft cloth to clean the collimator. This reduces the possibility for liquids to en-
ter the collimator.
– Do not use abrasive cleaning products.
CAUTION!
Use of abrasive cleaning could result in deterioration of the collimator. E.g. the cross-
hair window can be damaged, resulting in reduction of light field illumination.
–
CAUTION!
Do not spray, pour, or soak the collimator with liquids
• Use a dry soft cloth to remove any residuals form the collimator.
When there is a structural damage to the housing of the collimator, label the collimator as
“out of order” and have have the collimator repaired prior to further use.
ARCOMA AB 1000-095-051-EN Rev. 1.1
Operation Manual
SWEDEN Page 142 2020-06-16
To Next Page
Loading...