ARCOMA PRECISION i5 - Adjustment of Generator Parameters (Kv, Ma, Ms, Mas, Density); Settings

User Interface
Automatic Collimator Control
3.2.5 Adjustment of Generator Parameters (kV, mA, ms, mAs, Density)
In order to change the exposure values, the button with the parameter that shall be changed,
is pushed. Then the user may select to increase or decrease the value.
kV
150
+
150
150
+
5
5
Fig. 3-8 Adjustment of generator parameters
Note!
The Operator/User is always responsible for checking and validating the exposure parame-
ters in the Image system before performing exposure.
3.2.5.1 Exposure Index
The exposure index, EXI, is a measure of the amount of exposure received by the detector
and depends on mAs, the total detector area irridiated respective the beam attenuation. It is
indicative of the image quality.
3.2.6 Settings
The Setting menu is reached by a activating the Setting button for 1 second.
Fig. 3-9 Setting button
The Setting menu has the following tabs; User Settings and Service.
User settings has the following tabs: Display, Settings and Themes.
Service has the following tabs: Log, Settings and Display.
ARCOMA AB 1000-095-051-EN Rev. 1.1
Operation Manual
SWEDEN Page 48 2020-06-16