Arctic Cat 2007 - Accessory Receptacle;Connector; Battery; Brakelight Switch; RPM Limiter

5-2
Specifications
Battery
For battery-related information, see Section 2.
RPM Limiter
 NOTE: The Prowler/XT models are equipped with
a CDI unit that retards ignition timing when maxi-
mum RPM is approached. When the RPM limiter is
activated, it could be misinterpreted as a
high-speed misfire.
Testing Electrical
Components
All of the electrical tests should be made using the
Fluke Model 73 Multimeter (p/n 0644-191) and
when testing peak voltage, the Peak Voltage Read-
ing Adapter (p/n 0644-307) must be used. If any
other type of meter is used, readings may vary due
to internal circuitry. When troubleshooting a spe-
cific component, always verify first that the fuse(s)
are good, that the bulb(s) are good, that the connec-
tions are clean and tight, that the battery is fully
charged, and that all appropriate switches are acti-
vated.
 NOTE: For absolute accuracy, all tests should be
made at room temperature of 68° F.
Accessory
Receptacle/Connector
 NOTE: This test procedure is for either the
receptacles or the connectors.
VOLTAGE
1. Turn the ignition switch to the ON position; then
set the meter selector to the DC Voltage posi-
tion.
2. Connect the red tester lead to the red/white wire
or the positive connector; then connect the black
tester lead to ground.
3. The meter must show battery voltage.
 NOTE: If the meter shows no battery voltage,
troubleshoot the battery, fuse, receptacle, connec-
tor, or the main wiring harness.
Brakelight Switch
The switch connector is the two-prong black con-
nector below the master cylinder.
 NOTE: The ignition switch must be in the ON
position.
Prowler/XT
IGNITION
Ignition Timing 10° BTDC @ 1500 RPM
Spark Plug Type Champion RG6YC
Spark Plug Gap 0.7-0.8 mm
(0.028-0.032 in.)
Spark Plug Cap 3750-6250 ohms
Ignition Coil
Resistance
(primary)
(secondary)
Less than 1 ohm
(terminal to ground)
5200-7800 ohms
(high tension - plug cap
removed - to ground)
Ignition Coil Peak
Voltage
(primary/CDI) 142.4-213.6 DC volts
(blue/white to ground)
MAGNETO
Magneto Coil
Resistance
(trigger)
(source)
(charging)
160-240 ohms
(green to blue)
Less than 1 ohm
(yellow to white)
Less than 1 ohm
(black to black)
Magneto Coil
Peak Voltage
(trigger)
(source)
4.2-6.3 volts
(green to blue)
0.40-0.62 volt
(yellow to white)
Stator Coil Out-
put
(no load) 60 AC volts @ 5000
RPM
(black to black)
Magneto Output (approx) 325W @ 5000 RPM
Back to TOC
Back to Section TOC
Next
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com