EasyManua.ls Logo

Arctic Cat 2007 - Low Range;High Range;Neutral;Reverse Lever; Switches

Arctic Cat 2007
184 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2-13
2
2. Measure the distance from the floor to the
mid-point of each headlight.
3. Using the measurements obtained in step 2,
make horizontal marks on the aiming surface.
4. Make vertical marks which intersect the hori-
zontal marks on the aiming surface directly in
front of the headlights.
5. Switch on the lights. Make sure the HIGH beam
is on. DO NOT USE LOW BEAM.
6. Observe each headlight beam aim. Proper aim is
when the most intense beam is centered on the
vertical mark 5 cm (2 in.) below the horizontal
mark on the aiming surface.
0740-647
7. Using the adjuster knob, adjust each headlight
until correct aim is obtained.
CD714A
Switches
Each time the vehicle is used, switches should be
checked for proper operation. Use the following list
for reference.
A. Ignition/start switch — engine will run;
starter will engage.
B. 2WD/4WD selector switch — differential
will engage (4WD)/disengage (2WD).
C. Reverse/neutral/high/low switch — R/N/H/L
will be indicated on the LCD.
D. Headlight switch — high beam, low beam,
and lights off can be selected.
E. Brake switch — brakelight illuminates and
starter can be engaged with vehicle in gear.
Low Range/High Range/
Neutral/Reverse Lever
CHECKING SHIFT LEVER LINKAGE
Set the parking brake and turn the ignition switch
on; then with the shift lever in the neutral position,
look for the (N) indication on the LCD. Shift into
high range and look for the (H) indication, low
range for the (L) indication, and reverse for the (R)
indication. Shift the transmission into neutral and
turn the ignition switch off.
PR094
ADJUSTING SHIFT LEVER LINKAGE
To adjust the shift lever linkage, use the following
procedure.
1. Set the parking brake; then remove the seats and
center console.
2. Make sure the shift lever is in neutral; then
loosen the jam nut on the linkage.
3. Remove the E-clip on the transmission shift
arm; then remove the linkage from the shift arm.
Account for a washer and a bushing.
Back to TOC
Back to Section TOC
Next
Back
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com

Table of Contents

Other manuals for Arctic Cat 2007

Related product manuals