Arctic Cat 2007 - Suspension

6-3
6
PR189A
3. Remove the mounting cap screw from above the
actuator on the suspension side.
PR190A
4. Loosen but do not remove the mounting cap
screw at the front of the actuator; then slide the
actuator to the rear enough to clear the slotted
mounting tab and the selector shaft. Remove
from the right side.
AG928
INSTALLING
1. Lubricate the O-ring on the actuator; then ensure
that all mounting surfaces are clean and free of
debris.
2. Align the actuator with the selector shaft and
slide it forward onto the shaft taking care to
engage the cap screw in the slot of the front
mounting tab.
AG925
3. While holding the actuator firmly forward,
tighten the front cap screw to hold the actuator
in place; then install but do not tighten the two
remaining cap screws.
AG928
4. Loosen the front cap screw; then tighten the cap
screw on the driveshaft side.
AG926
 NOTE: It is important to tighten this cap screw
while the others are loose to ensure proper seating
of the actuator.
5. Tighten the remaining cap screws; then connect
the electrical plug to the main harness.
6. Turn the ignition switch to the ON position and
check the operation by shifting the selector
switch several times.
Back to TOC
Back to Section TOC
Next
Back
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com