4-9
4
PR166A
4. Place the gas cap filler panel into position; then
if necessary, position the gas tank so the filler
panel and filler neck are not binding or rubbing.
PR176
5. Secure the filler panel with four press-nuts; then
tighten the hardware securing the hold-down
straps (from steps 2-3) securely.
PR166A
PR167A
6. Connect the gasline hose and gas tank vent hose
to the proper fittings; then connect the fuel level
sensor connector (XT) to the main harness.
PR166D
7. Position the floorboard into the vehicle and
secure with the appropriate hardware; then
install the center console, seat-bases, and seats
making sure the seats lock securely.
Gas/Vent Hoses
Replace the gas hose every two years. Damage from
aging may not always be visible. Do not bend or
obstruct the routing of the carburetor vent hose.
Make certain that the vent hose is securely con-
nected to the carburetor and the opposite end is
always open.
Vacuum Pulse Fuel
Pump
The vacuum pulse fuel pump is a nonserviceable
assembly. If the pump fails, it must be replaced.
Back to TOC
Back to Section TOC
Next
Back
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
