Arctic Cat 2007 - Left-Side Components; Removing Left-Side Components

3-14
PR434A
Left-Side Components
 NOTE: For efficiency, it is preferable to remove
and disassemble only those components which
need to be addressed and to service only those
components. The technician should use discretion
and sound judgment.
 NOTE: The engine/transmission does not have
to be removed from the frame for this procedure.
Removing Left-Side
Components
A. V-Belt Cover
B. Driven Pulley
C. Clutch Cover
1. Remove the cap screws securing the V-belt
cover noting the location of the differ-
ent-lengthed cap screws for installing purposes;
then using a rubber mallet, gently tap on the
cover tabs to loosen the cover.
CD079
2. Remove the nut securing the movable drive
face; then remove the face. Account for a spacer.
CD963
CD966A
3. Remove the V-belt.
4. Remove the nut securing the fixed driven
assembly; then remove the assembly.
 AT THIS POINT
To service any one specific component, only limited
disassembly of components may be necessary. Note
the AT THIS POINT information in each sub-section.
Back to TOC
Back to Section TOC
Next
Back
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com