6-24
PR258
5. For front hubs, secure the brake calipers to the
knuckle with two cap screws tightened to speci-
fications.
PR377B
6. Install the wheel and tighten to specifications.
7. Remove the vehicle from the support stand.
Hydraulic
Brake Caliper
NOTE: The brake caliper is a non-serviceable
component; it must be replaced as an assembly.
REMOVING/DISASSEMBLING
1. Secure the vehicle on a support stand to elevate
the wheel; then remove the wheel.
2. Drain the brake fluid from the caliper, hose, and
master cylinder.
PR235
3. Remove the brake hose from the caliper; then
remove the caliper and plug the brake fluid port.
4. Compress the caliper holder against the caliper
and remove the outer brake pad; then remove
the inner brake pad.
PR237
PR238
5. Remove the caliper holder from the caliper and
account for the brake caliper O-ring. Do not
remove the piston from the caliper.
! WARNING
Make sure the vehicle is solidly supported on the
support stand to avoid injury.
! CAUTION
Brake fluid is highly corrosive. Do not spill brake
fluid on any surface of the vehicle and do not reuse
brake fluid.
Back to TOC
Back to Section TOC
Next
Back
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
To Next Page
