4-8
PR168
8. Remove the joining cap screw and nut from the
rear gas tank hold-down strap; then remove the
inside hold-down strap.
PR172A
9. Lift and slide the tank forward raising the front
of the tank first; then turn the tank and lift out
the right side.
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean all gas tank components with parts-clean-
ing solvent.
2. Inspect all hoses for cracks or leaks.
3. Inspect gas tank cap and tank for leaks, holes,
and damaged threads.
4. On the XT, inspect the fuel level sensor for
proper operation (see Fuel Level Sensor (XT) in
this section).
INSTALLING
1. Place the gas tank into position in the vehicle;
then install the inside rear hold-down strap.
PR173
PR172A
2. Swing the front hold-down to the right into posi-
tion and install the cap screw and nut. Do not
tighten at this time.
PR171
3. Install the rear hold-down strap joining cap
screw and nut. Do not tighten at this time.
! WARNING
Whenever any maintenance or inspection is made
on the fuel system during which there may be fuel
leakage, there should be no welding, smoking, open
flames, etc., in the area.
Back to TOC
Back to Section TOC
Next
Back
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
To Next Page
Loading...
