AT&T 1080 - Switching Among Handset, Speakerphone and Headset Mode; Timer

12
Telephone operation
Basic phone operation
Switching among handset, speakerphone and
headset mode
To switch from handset to headset or
speakerphone, press [HEADSET] or [ SPEAKER],
then replace the handset. (In order to use the
headset, it must be plugged in.)
To switch from speakerphone to handset, lift the
handset. (Do not press [ SPEAKER], or the call
will be disconnected.)
To switch from speakerphone to headset, insert
the headset plug into the jack on the side of the
telephone base, and press [HEADSET].
To switch from headset to handset when
the handset is in the telephone base, lift the
handset.
To switch from headset to handset when the
handset is off-hook, press [HEADSET] again.
To switch from headset to speakerphone, press
[ SPEAKER].
To override automatic line selection, press
and release a line button. This activates
the speakerphone or headset, whichever is
programmed as the default mode.
Timer
When you make or answer a call, the timer
automatically starts. The screen displays the
elapsed time in minutes and seconds for the first
hour (up to 59:59) and then begins again. The
timer stops automatically when you hang up and
the recorded time displays for about 10 seconds.
The timer also stops when you place a call on
hold and resets to 00:00 when you release the
hold.
10:01AM 11/23
00:30
5550100