40
One-touch setup and operation
To modify a one-touch number
Use the following steps to modify a one-touch
number.
1. When a one-touch telephone number displays,
press [ ] or [ ] to highlight MODIFY.
2. Press
[ENTER].
3. Press the dial pad keys to enter up to 24 digits.
• You can include a pause while modifying
a dialing sequence that requires one during
actual dialing. Press [ ] or [ ] until you see
PAUSE, then press [ENTER] when storing
a pause. The screen displays P. Each pause
counts as one digit. Continue storing the
number as usual.
• Storing a signal for switching to temporary
tone dialing. If you have dial pulse (rotary)
service, this signal is required for some special
services. Press [ ] or [ ] until you see TONE,
then press [ENTER]. A T appears on the
screen. All numbers entered after this send
touch tone signals during dialing.
• You can store the flash
signal required by
some special services as part of a dialing
sequence. Press [ ] or [ ] until you see
FLASH, then press [ENTER]. An F appears on
the screen. Continue storing the number as
usual.
• To erase the last digit, scroll to DELETE
CHAR and then press [ENTER].
-OR-
Press
[REMOVE].
•
To copy the most recently dialed number
from redial, press [(AUTO) REDIAL]. You can
copy only the last number dialed from this
extension to a one-touch location. You cannot
copy the other numbers in the redial stack.
•
To cancel programming, scroll to CANCEL
and then press [ENTER].
Continued on next page
VIEW SPD#01
5550100
MODIFY
To Next Page
Loading...
