AT&T 1080 User Manual

67
DTAD SETUP
ON
MESSAGE ALERT
Answering system operation
DTAD setup
REMOTE CODE
Use this feature to select a three-digit number to
enable remote access from another telephone
(away from your home, page 59 of the installation
guide) and internal access from the SYS EXT
telephones (See the 1070 or 1040 user's manual
for details). This code is 111 by default.
1. Press
[ENTER].
2. Press [ ] or [ ] until you see DTAD SETUP. Press
[ENTER].
3. Press
[ ] or [ ] until you see REMOTE CODE.
4.
Press and hold [ ] to delete the current code.
Press the dial pad keys to enter a three-digit
remote access code (000-999).
5.
To move to the next feature, press [ ].
-OR-
To exit setup,
press and hold [ENTER].
MESSAGE ALERT
Use this feature to turn the audible message alert
on or off.
If the message alert tone is on, the telephone
beeps every 30 seconds when there are new
private or central messages.
1. Press
[ENTER].
2. Press
[ ] or [ ] until you see DTAD SETUP. Press
[ENTER].
3. Press
[ ] or [ ] until you see MESSAGE ALERT.
4. Press
[ ] or [ ] to choose ON or OFF.
5.
To move to the next feature, press [ ].
-OR-
To exit setup,
press and hold [ENTER].
DTAD SETUP
= 111
REMOTE CODE

AT&T 1080 Specifications

General

Brand	AT&T
Model	1080
Category	Telephone
Language	English