AT&T 1080 - Store a Temporary Tone Signal in a Directory Number; Store a FLASH in a Directory Number

45
Directory
Store a name and number in the
directory
Store a temporary tone signal in a directory
number
If you have dial pulse (rotary) service, use this
feature to store tone signals in a directory number.
You might need tone signals to use bank-by-
phone and other services.
1. When you reach the place in the dialing
sequence where you wish tone dialing to begin,
press [ ] until the screen displays TONE.
2. Press
[ENTER]. All digits entered after this send
tone signals.
3. If you want to save the number in the directory,
press [ ] to reach DONE, and then press
[ENTER] to save.
Store a FLASH in a directory number
Use this feature to store the flash needed to
access some custom-calling services in a directory
number.
1. When you reach the place in the dialing
sequence where you wish to enter a flash, press
[ ] until the screen displays FLASH.
2. Press
[ENTER] to store the flash, then continue
entering the number. Each flash counts as one
digit.
3. When you want to save the number in the
directory, press [ ] to reach DONE and then
press [ENTER] to save.
Pat Williams
5550100
TONE
Pat Williams
5550100
FLASH