AT&T 1080 User Manual

48
Directory
Dial and remove an entry from the
directory
Dial a number from the directory
Use the following steps to dial a number from the
directory.
1. Find the entry for the number you wish to
call by following the directions under Review
directory entries on page 46.
2. Press [ENTER]. The screen displays DIAL.
3. Press
[ENTER].
The phone automatically selects an idle line and
dials the call unless you choose a specific line
by pressing the [LINE] button; the call is then
dialed in the mode (speakerphone or headset) you
programmed (see AUTOMATIC MODE on page 39
of the installation guide).
NOTE: While reviewing the numbers in the
directory, if you want to place a new call to a
number other than the displayed number, you
need to press [DIR] or wait for 30 seconds to
return to idle mode.
Remove a name and number from the directory
Use the following steps to remove an entry from
the directory.
1. Find the entry for the number you wish to
call by following the directions under Review
directory entries on page 46.
2. When the desired entry displays, press
[REMOVE]. The screen includes REMOVED!
The screen automatically advances to the next
directory entry.
NOTE: Once you have removed an entry from
the directory, you cannot restore it.
Pat Williams
5550100
DIAL
Pat Williams
5550100
REMOVED!

AT&T 1080 Specifications

General

Brand	AT&T
Model	1080
Category	Telephone
Language	English