AT&T TL87203 - Call Screening On;Off

127
Answering system
Call screening on/o
Use this feature to choose whether incoming messages can be heard over the
speaker when they are being recorded. If you turn call screening on, you hear
the incoming message. While monitoring an incoming message, you can answer
the call by pressing LINE 1/FLASH, LINE 2/FLASH, or /SPEAKER on a cordless
handset, or pressing 1 LINE, 2 LINE, or SPEAKER on the telephone base. You
can also li the corded handset to answer the incoming call.
Answering system settings
To change the setting:
Using the telephone base:
1. When the telephone base is in idle mode, press MENU
to enter the main menu.
2. Press SELECT to select Answering system.
3. Press CID, DIR, /RECORD, or /DELETE to
highlight Mailbox 1 or Mailbox 2, and then
press SELECT .
4. Press CID, DIR, /RECORD, or /DELETE to
highlight Ans system setup, and then press SELECT .
5. Press SELECT to select Call screening.
6. Press CID, DIR, /RECORD, or /DELETE to choose On or O.
7. Press SELECT to save the setting. You hear a conrmation tone.
NOTE: For more information on call screening, see page 134.
ANS SYSTEM SETUP
Call screening
# of rings
Remote code
BACK SELECT
CALL SCREENING
On
Off
BACK SELECT
p
q
p
q