AT&T TL87203 - Replace an Active Device

43
Bluetooth
DEVICE LIST
A:Cell Phone B
B:Headset A
Cell Phone A
BACK OPTION
DEACTIVATE
A:Cell Phone A
B:Headset A
BACK NEXT
Connecting
Cell Phone B
to the base...
DEVICE LIST
A:Cell Phone A
B:Headset A
Cell Phone B
BACK OPTION
BLUETOOTH
Add device
Device list
Download dir
BACK SELECT
Only 2 devices
can be ready
for connection
NOTE: When adding removing, or replacing a Bluetooth device on the active devices list, all
connected devices are temporarily disconnected until the procedure completes. It may take
up to two minutes to reconnect.
Bluetooth setup
Replace an active device
If you already have 2 active devices and you want to activate a dierent one,
you must deactivate one of the 2 active devices.
To replace an active device:
1. Press MENU on the telephone base in idle mode.
2. Press CID, DIR, /RECORD, or /DELETE to
highlight Bluetooth, and then press SELECT .
3. Press CID, DIR, /RECORD, or /DELETE to
highlight Device list, and then press SELECT .
4. Press CID, DIR, /RECORD, or /DELETE to
highlight the device you want to activate without
a prex A: or B:, and then press OPTION .
5. Press CID, DIR, /RECORD, or /DELETE to
highlight Connect, and then press SELECT . The
handset displays Only 2 devices can be ready for
connection, and then a list of devices
for deactivation.
6. Press CID, DIR, /RECORD, or /DELETE to
highlight the device to be deactivated, and then
press NEXT . The screen displays Cell Phone X is
deactivated or Headset X is deactivated (X represents
the slot of the deactivated device) and you hear a
conrmation tone. Then, the screen displays Connecting
Cell Phone X to the base... or Connecting Headset X
to the base... (X represents the slot of the replacement
device).
7. Depending on your cell phone settings, you may
need to press a key on your cell phone to conrm
the connection. When the new device is successfully
activated and connected, the handset displays
Device connected. You hear a conrmation tone.