AT&T TL87203 - Message Playback and Management

128
Answering system
Answering system settings
Number of rings
You can set the answering system to answer an incoming call aer two, three,
four, ve or six rings. You can also select toll saver. If toll saver is selected, the
answering system answers a call aer two rings when you have new messages,
and aer four rings when there are no new messages. This feature allows you
to check for new messages and avoid paying long distance charges when
calling from out of your local area. By default, the answering system answers
an incoming call aer four rings.
To set the number of rings:
Using the telephone base:
1. When the telephone base is in idle mode, press MENU to
enter the main menu.
2. Press SELECT to select Answering system.
3. Press CID, DIR, /RECORD, or /DELETE to
highlight Mailbox 1 or Mailbox 2, and then
press SELECT .
4. Press CID, DIR, /RECORD, or /DELETE to
highlight Ans system setup, and then press SELECT .
5. Press CID, DIR, /RECORD, or /DELETE to
highlight
#
of rings, and then press SELECT .
6. Press CID, DIR, /RECORD, or /DELETE to choose
among 6, 5, 4, 3, 2, or Toll saver.
7. Press SELECT to save the setting. You hear a conrmation tone.
NOTE: If you set the number of rings for the answering system as 2 or 3 rings, the caller ID
announce feature may not have enough time to announce the caller’s full information.
ANS SYSTEM SETUP
Call screening
# of rings
Remote code
BACK SELECT
# OF RINGS
6
5
4
BACK SELECT
p
q
p
q