AT&T TL87203 - Message Alert Tone

130
Answering system
Answering system settings
Message alert tone
When the message alert tone is set to On, and there is at least one new
message, the telephone base beeps every 10 seconds. Unless you change it, the
message alert tone is set to o.
There is no audible alert at the handset.
To change the setting:
Using the telephone base:
1. When the telephone base is in idle mode, press MENU
to enter the main menu.
2. Press SELECT to select Answering system.
3. Press CID, DIR, /RECORD, or /DELETE to
highlight Mailbox 1 or Mailbox 2, and then press
SELECT .
4. Press CID, DIR, /RECORD, or /DELETE to
highlight Ans system setup, and then press SELECT .
5. Press CID, DIR, /RECORD, or /DELETE to
highlight Msg alert tone, and then press SELECT .
6. Press CID, DIR, /RECORD, or /DELETE to choose On or O.
7. Press SELECT to save the setting. You hear a conrmation tone.
NOTES:
X The message alert tone beeps only if all the following conditions are met:
- Answering system is on.
- Message alert tone setting is on.
- There are new messages.
X To temporarily turn o the message alert tone, see page 133.
ANS SYSTEM SETUP
# of rings
Remote code
Msg alert tone
BACK SELECT
MSG ALERT TONE
On
Off
BACK SELECT
p
q
p
q