AT&T TL87203 - Answer On;Off

126
Answering system
Answering system settings
Answer on/o
Unless you change it, the answering system is on and ready to record messages.
You can turn the answering system o, but if you do so, the answering system
does not answer calls and record incoming messages.
To turn the answering system on or o:
Using the telephone base:
Press /LINE 1 ANS ON/OFF or /LINE 2 ANS
ON/OFF to turn the corresponding answering
system on or o. If the answering system is
turned on, it announces, “Calls will be answered.”
If the answering system is turned o, it
announces, “Calls will not be answered.”
-OR-
1. When the telephone base is in idle mode,
press MENU to enter the main menu.
2. Press SELECT to select Answering system.
3. Press CID, DIR, /RECORD, or /DELETE
to highlight Mailbox 1 or Mailbox 2, and
then press SELECT .
4. Press CID, DIR, /RECORD, or /DELETE
to highlight Answer ON/OFF, and then
press SELECT .
5. Press CID, DIR, /RECORD, or /DELETE
to highlight On or O, and then press
SELECT to save the setting. You hear a
conrmation tone.
NOTE: If the answering system is off and there is an incoming call, the system answers after
ten rings and announces, “Please enter your remote access code.” For more information about
remote access, see page 140.
Play messages
Answering system
Directory
Caller ID log
SELECT
BACK
ANSWER ON/OFF
On
Off
SELECT
BACK
ANSWERING SYSTEM
Delet e all old
Record memo
Answer ON/OFF
SELECT
BACK
p
q
p
q
p
q