AT&T TL87203 - Headset Battery Installation

16
Getting started
NOTE: Remove any headset attachment, except the earbud, before battery replacement.
1. Insert the battery into the battery compartment.
2. Press down on the battery until it clicks into place.
Headset battery installation
4. The magnet holds the top
of the headset in place.
The light turns on.
3. Insert the headset into the
magnetic charging mount.
Magnetic
charging mount
IMPORTANT INFORMATION:
X Use only the supplied rechargeable battery pack or replacement headset battery pack. To
order a replacement battery (model BT191665/BT291665), visit our website at
www.telephones.att.com or call 1 (800) 222-3111. In Canada, dial
1 (866) 288-4268.
The headset battery is permanently attached to the battery compartment
cover. Do not try to separate them from each other. Aer installing the
battery, charge it for at least 15 minutes. You may be able to make and
receive short calls. For optimal performance, charge the headset battery
for at least three hours before use. When fully charged, the headset battery
provides approximately 12 hours of talk time or 5 days of standby time. When
the headset is not in use, recharge it by returning it to the headset charger.
Battery installation and charging
1
2
Charging light