AT&T TL87203 - Voice Command and Conference Calls

69
Telephone operation
Telephone operation
To transfer a call from a cordless handset or the telephone base to a
cordless headset or speakerphone:
Using a cordless handset or the telephone base:
1. Press OPTION during a call on line 1 or line 2.
2. Press CID or DIR on the handset, or CID, DIR, /RECORD, or
/DELETE on the telephone base, to highlight Intercom, and then press
SELECT .
3. Press CID or DIR on the handset, or CID, DIR, /RECORD, or
/DELETE on the telephone base, to highlight HDST/SPK, and then
press SELECT .
4. Press the call key on your cordless headset to answer the intercom call.
5. Press OPTION during the intercom call.
6. Press CID or DIR on the handset, or CID, DIR, /RECORD, or
/DELETE on the telephone base, to highlight Transfer, and then
press SELECT .
NOTE: If a total of two cordless headset(s) and or speakerphone(s) are registered, they will
appear as HDST/SPK 1 and HDST/SPK 2, respectively, in the intercom menu during a call.
Call waiting on line 1 or line 2
If you subscribe to call waiting service oered by your telephone service
provider, and someone calls while you are already on a call on the same line, you
hear a call waiting alert tone.
Using a cordless handset or the telephone base:
X Press the corresponding line button, LINE 1/FLASH or LINE 2/FLASH on the
handset, or FLASH on the telephone base to put your current call on hold
and take the new call.
X Press the same key at any time to switch back and forth between calls.
Using a cordless headset:
X Press down the FLASH switch at the top of the headset to put your current
call on hold and answer the new call.
X Press the FLASH switch again at any time to switch back and forth between
calls.