AT&T TL87203 - Remote Access Code

129
Answering system
Answering system settings
Remote access code
To access your answering system remotely from any touch-tone phone, you
need to enter a two-digit number (00-99). By default, the remote access code is
19.
Using the telephone base:
1. When the telephone base is in idle mode, press MENU to
enter the main menu.
2. Press SELECT to select Answering system.
3. Press CID, DIR, /RECORD, or /DELETE to highlight
Mailbox 1 or Mailbox 2, and then press SELECT .
4. Press CID, DIR, /RECORD, or /DELETE to
highlight Ans system setup, and then press SELECT .
5. Press CID, DIR, /RECORD, or /DELETE to
highlight Remote code, and then press SELECT .
6. Use the dialing keys to enter a two-digit number. Press /DELETE to
backspace and delete a digit.
7. Press SAVE to save the setting. You hear a conrmation tone.
REMOTE CODE
19
BACK SAVE
ANS SYSTEM SETUP
Call screening
# of rings
Remote code
BACK SELECT
p
q
p
q