AT&T TL87203 - Handset Charger Installation

12
Getting started
Telephone base and charger installation
Option 2: If you have a 2-line wall jack, plug the 4-conductor black telephone
line, as shown below.
Handset charger installation
Plug the power adapter into an
electrical outlet not controlled by
a wall switch.
Route the cord through
the slot.
Raise the antenna.
Line 1 + line 2
telephone wall jack
Plug one end of the black telephone line cord into the
LINE 1/L1+L2 telephone jack at the bottom of the telephone base.
Plug the other end of the
black telephone line cord
into the telephone wall
jack, or into a DSL lter if
you have DSL high-speed
Internet service.
Plug the large end of the
telephone base power adapter
into a power outlet not
controlled by a wall switch.
Route the cord
through the slot.
Plug the other end of the coiled
handset cord into the jack on
the back of the telephone base.
Plug the small end of the
telephone base power adapter
into the power adapter jack on
the back of the telephone base.