41
Bluetooth
Bluetooth setup
Auto connection
When an active device moves within Bluetooth range of the telephone base,
or is turned on within range, the telephone base tries to connect to the device.
When the device moves out of range, it is disconnected. Your device might
make a connect or disconnect sound.
A connected device could also be disconnected by:
X Turning o the Bluetooth device.
X Turning o the Bluetooth feature of the device.
X Disconnecting through the telephone base Device list. If you disconnect
through the Device list, the telephone base will not attempt to reconnect
until your device is moved out of range and then back in range again.
Bluetooth connection from idle mode
When you have active devices that are not connected, CONNECT appears
on the telephone base in idle mode. Press CONNECT on the telephone base
to start connecting an active device. When there are two active devices, the
screen will prompt you to choose one before connection.
Device list and connection
Up to 4 devices can be paired to the telephone base. All paired devices are
shown on the device list. To use a paired device, it must be in an active slot
(A: or B:) on the device list and connected. Both Bluetooth-enabled devices can
be on a call at a time.
Once you have paired a device with the telephone base, you do not need to
repeat the pairing procedure again unless you delete the device from the
device list.
Review the device list
1. Press MENU on the telephone base in idle mode.
2. Press CID, DIR, /RECORD, or /DELETE to highlight Bluetooth, and
then press SELECT .
3. Press CID, DIR, /RECORD, or /DELETE to highlight Device list, and
then press SELECT .
NOTE: When connecting a Bluetooth device to the device list, all connected devices will
be temporarily disconnected until the procedure is complete. It may take up to two minutes
to reconnect.
To Next Page
Loading...
