AT&T TL87203 - Options While on Calls; Silencing the Ringer; Page All Devices

80
Telephone operation
Options while on calls
Silencing the ringer
When the telephone is ringing, you can temporarily silence the ringer of the
cordless handset or telephone base without disconnecting the call. The next
call rings normally at the preset volume.
To silence the handset ringer:
Using a cordless handset:
Press SILENCE , OFF/CANCEL, MUTE/DELETE, or QUIET
#
. The handset screen
displays Ringer muted.
To silence the base ringer:
Using the telephone base:
Press SILENCE , CANCEL, or QUIET
#
. The telephone base screen displays
Ringer muted.
To silence the headset earpiece ringer:
Press MUTE/VOICE to temporarily silence the ringer in the headset earpiece.
This silences the ringer without disconnecting the call. The next incoming call
rings normally at the preset volume.
Page all devices
This feature helps you nd the misplaced devices.
To start paging:
Using the telephone base:
1. Press MENU in idle mode.
2. Press Page all devices, and then press SELECT to start the paging tone on
all handsets for 60 seconds. All idle handsets ring and display ** Paging **.
To stop the paging tone on a cordless handset:
Press SILENCE , MUTE/DELETE, QUIET
#
, or OFF/CANCEL.
To end paging:
Using a cordless handset:
Press STOP on the telephone base, or LINE 1/FLASH, LINE 2/FLASH, /SPEAKER,
A CELL, B CELL , or any dialing key (0-9 or TONE ) on the handset.
Using the telephone base:
Press SPEAKER , 1 LINE, 2 LINE, CELL A , CELL B , DELETE, QUIET
#
, or
CANCEL on the telephone base.
NOTES:
X If the handset ringer volume is set to o, the handset still rings when paging.
X If there is no response aer 60 seconds, the paging ends.