AT&T TL87203 - Connect;Disconnect an Active; Device; Remove a Paired Device

42
Bluetooth
Bluetooth setup
Connect/disconnect an active device
While in the device list menu, you may connect or disconnect your
active device.
1. Press MENU on the telephone base in idle mode to enter the main menu.
2. Press CID, DIR, /RECORD, or /DELETE to highlight Bluetooth, and
then press SELECT .
3. Press CID, DIR, /RECORD, or /DELETE to highlight Device list, and
then press SELECT .
4. Press CID, DIR, /RECORD, or /DELETE to highlight a device, and then
press OPTION .
5. Press CID, DIR, /RECORD, or /DELETE to highlight
Connect/Disconnect (whichever is applicable), and then press SELECT .
The telephone base displays Device connected/Device disconnected.
You hear a conrmation tone.
Remove a paired device
When you already have a maximum of 4 paired devices and you want to add
another device, you must rst delete one from the device list.
To remove a paired device:
1. Press MENU on the telephone base in idle mode to enter
the main menu.
2. Press CID, DIR, /RECORD, or /DELETE to
highlight Bluetooth, and then press SELECT .
3. Press CID, DIR, /RECORD, or /DELETE to
highlight Device list, and then press SELECT .
4. Press CID, DIR, /RECORD, or /DELETE to
highlight the desired device, and then press OPTION .
5. Press CID, DIR, /RECORD, or /DELETE to
highlight Remove, and then press SELECT .
6. The handset displays Remove Cell Phone X? or
Remove Headset X? (X represents the slot of the
device). Press YES to conrm. The telephone base
displays Device removed from device list and you
hear a conrmation tone.
NOTE: When your active device is connected, you are prompted to select Disconnect. When
your active device is disconnected, you are prompted to select Connect.
DEVICE LIST
A:Cell Phone A
B:Headset A
BACK OPTION
Remove
Headset A
?
NO YES
Headset A
Connect
Remove
BACK SELECT
BLUETOOTH
Add device
Device list
Download dir
BACK SELECT
Device removed
fr o m
device list