180
Appendix
California Energy Commission battery charging testing
instructions
This telephone is set up to comply with the energy-conserving standards right out of the box. These
instructions are intended for California Energy Commission (CEC) compliance testing only. When the
CEC battery charging testing mode is activated, all telephone functions on the cordless handsets and
cordless headsets, except battery charging, will be disabled.
To activate the CEC battery charging testing mode:
1. Press and hold HOLD on the telephone base for about 10 seconds in idle mode. The telephone base
shows Deregister all devices?. Then, release HOLD.
2. Quickly press HOLD again or press YES within two seconds.
When the cordless handset successfully enters the CEC battery charging testing mode, the
cordless handset screen displays To register HS, see manual..
When the cordless handset fails to enter this mode, repeat Step 1 to Step 2 mentioned above.
To deactivate the CEC battery charging testing mode:
Register your handsets and headsets back to the telephone base. See pages 142-143 for handset and
headset registration instructions.
BC
To Next Page
Loading...
