143
Appendix
Adding and registering cordless handsets/headsets/
speakerphones
Register a cordless headset to your telephone base
Using the telephone base:
1. Before you begin registration, make sure the battery is properly installed
in the headset (see page 16). The light ashes slowly in red and blue to
indicate the headset is not registered.
2. Place the headset in the headset charger and allow it to charge for at least
one hour before beginning registration.
3. Remove the headset from the charger.
4. Press MENU on the telephone base in idle mode.
5. Press CID, DIR, /RECORD, or /DELETE to highlight Settings, and
then press SELECT .
6. Press CID, DIR, /RECORD, or /DELETE to highlight Registration, and
then press SELECT .
7. The telephone base shows Registering... Please wait.
8. Place the headset back to the charger. The light ashes quickly in red and
blue.
It takes about 60 seconds to complete the registration process. The light
turns red when the headset is registered but not fully charged, or turns blue
when it is registered and fully charged.
To verify the registration, press the button on the headset and check for a
dial tone. If the registration fails, you hear the voice prompt “Not registered” and
the light on the headset ashes slowly in red and blue.
To reset the headset, remove it from the headset charger and try the
registration process again.
NOTE: You cannot register a headset if any other system device is in use.
To Next Page
Loading...
