38
Bluetooth
7. Once your cell phone nds your AT&T phone
(AT&T DECT 6.0), press the appropriate key on your cell
phone to continue the pairing process.
X Your cell phone may require a passcode. In this case,
the telephone base displays Check cellular. ENTER
PASSCODE. Enter the cell phone passcode (typically
0000) into the telephone base and press SET .
X Enter the PIN of the telephone base (the default PIN
is 0000) into your cell phone to continue the pairing
process, if required. The telephone base displays
Adding Cell Phone A.
8. When a device is successfully connected, the telephone base displays
Cell Phone A is added and connected to base. You hear a conrmation
tone. The corresponding status icon (A or B) displays. The
corresponding device light on the telephone base (CELL A and/or
CELL B/HEADSET ) turns on.
If you have trouble pairing your cell phone, it may not be compatible with
your TL87203. Check the Bluetooth compatibility list at
www.telephones.att.com/bluetooth.
NOTES:
X The pairing process may take up to one minute. If the pairing process fails, turn o the
Bluetooth feature on your cell phone and on the TL87203 by pressing Cell A or CELL B .
Repeat the steps, as mentioned above, to pair and connect again. In some cases, it may take you
a few attempts to complete the pair process.
X The steps for the pairing process may vary for dierent cell phones. If this happens, follow the
prompts on your cell phone and your TL87203 to complete the pairing process.
X Refer to the user’s manual of your cell phone on how to search for or add a new Bluetooth
device.
Adding
Cell Phone A
Cell Phone A
is added
and connected to
base.
Bluetooth setup
To Next Page
Loading...
