6.3.2 Fireman Microphone
Next steps are for zone call with the fireman microphone:
• Press the zone button(s) where you want the call to be played. The corresponding green selection
LED(s) should light(s) up
• Press the fireman microphone contact to start speaking in the selected zone(s), the corresponding
EVAC LED(s) should light(s) up
Note: If the fireman microphone paging event has pre-defined zones, pressing the microphone button
will start a call in the pre-defined zone. In case of doing a call in manually selected zone, the next
microphone call will take place in the pre-defined zones after a adjustable delay, see How To Use
Fireman Microphone.
Ateïs International
Ch. du Dévent, 1024 Ecublens, Switzerland.
Phone : +41 21 881 25 10
28
To Next Page
Loading...
