8 How To?
The How To section is divided by theme. Each Theme discusses about how to perform an action or
multiple action in order to build a configuration.
The Philosophy of this chapter is that if you read it from A to Z, you will be able to perform a full
advanced DIVA configuration. But it has been written to offer quick navigation so that you can find
specific information about one theme. Here under, you will find a complete list of the How To topics:
• Save/Open
• Print Project
• Start a New Project
• Change Colour Scheme
• Configure network Options
• Use the User Management
• Enter Password
• Update DIVA
• Compile
• Store
• Reverse
• Add design Component
• Search Device
• Set IP Adress
• Perform a DIVA Master Network
• Add Messages Into DIVA
• To Set Speaker Parameters Settings
• Use Events
• Set up Front Panel Messages
• Use a Fireman Microphone
• Use Music Source
• Use PSS Microphone
• Use Mic/Line Input
• Use Logic Inputs
• Use Monitoring
• Use the Scheduler
• Use filters
• Use PEQs
• Use Compressor/Limiter
• Use Preset
• Use Output Relay
• Create a Monitorable Button
• Wire things
• Use Tone Generator
Note: Some topics could be divided in sub-topics as the procedure could induce multiple procedure to
achieve the main goal.
8.1 Save/Open
The Save/Open procedure is quite identical to most of the Microsoft Windows based software. The
icon used as well as keyboard shortcuts are well-known for Microsoft Windows users.
Ateïs International
Ch. du Dévent, 1024 Ecublens, Switzerland.
Phone : +41 21 881 25 10
41
To Next Page
