• Type: display the type of event you are creating or modifying
• Name: here you can specify a name for the event created. Default is Event X
• Priority: here you can adjust the priority of the event. 20 is the lowest, 0 is the highest
• Attrib: here you can specify if this event is a security one or not. See Common Option to learn
more about the security option
______________________________________
• Next Event: here you can select the event to start after the current on is finished
______________________________________
• Active at Start: Ticking this option allows user to close an output contact (Logic Output channel)
in two different manner. Static will close it until the event stop and Pulse will generate a closing
pulse whose length can be defined from 50 to 60000 ms.
• Active at Stop: This option is used to create a closing contact pulse when the event is finished.
The length of the pulse can be defined from 50 to 60000 ms.
Ateïs International
Ch. du Dévent, 1024 Ecublens, Switzerland.
Phone : +41 21 881 25 10
71
To Next Page
Loading...
