5.Measure
.Length @of brush (every one)
Out of specification ¡úreplace it
6.Measure
.Brushing spring force
Fatigue/out of specification¡ú replace whole
device
Length of brush:10mm(0.39 inches)
Range of wear:<6mm(0.14 inches)>
Brushing spring force:326~970g(3.2~3.
8N)
7.Check
.Oil sealing
.Bushing
.O-ring
Wear/damage ¡úrepalce it
Installation of starting motor:
1.Mount
.Magnetic steel
.Bracket
Remark
Mark the matching mark @On the magnetic
steel is align to that on the bracket.
- 127 -
To Next Page
Loading...
